Arduino.TW樂園

Wii and Atmega8  (Step pic )


Atmega8晶片除了待在Arduino NG上，還能在Wii效力。
Firmware from: http://chiip.dl.am/
Flashing device: http://www.xs4all.nl/~sbolt/e-spider_prog.html
Wii device from: ....

Other Keyword for chip:
wiiKEY CHIIP Wiinja CycloWiz Wiimod WiiBuster Wi-ic
Wiinja-Deluxe Wiiskas WiiFree
8粒晶片官方網頁......
http://www.wiinja.com/
http://www.teamcyclops.com/
http://www.wiikey.cn/
http://www.tcniso.net/Nav/Wiip/
http://www.wiimod.es/
http://www.wiibuster.com/index.php?s=5&l=en
http://www.wi-ic.com/








begin 0793
-i793
-iM8
DEVICENAME = ATmega8
FLASHSIZE = 4096
EEPROMSIZE = 512
PAGEMODE = 1
PAGESIZE = 32
READ_LOCK = lhlh hlll llll llll xxxx xxxx xxoo oooo
WRITE_LOCK = hlhl hhll hhhx xxxx xxxx xxxx hhii iiii
LOCK_MESSAGE = xxxx11 - no lock
LOCK_MESSAGE = xxxx10 - write protected
LOCK_MESSAGE = xxxx00 - read/write protected
LOCK_MESSAGE = BTLKxx - Boot lock, datasheet p116
READ_FUSES = lhlh llll llll llll xxxx xxxx oooo oooo
WRITE_FUSES = hlhl hhll hlhl llll xxxx xxxx iiii iiii
FUSES_MESSAGE = 0xxxxxxx - BODLEVEL 4V (default 2.7V)
FUSES_MESSAGE = x0xxxxxx - brownout detection enabled
FUSES_MESSAGE = xxSUxxxx - reset delay, datasheet p28
FUSES_MESSAGE = xxxxCKSE - clock select, datasheet p24
WRITE_HIGH_FUSES = hlhl hhll hlhl hlll xxxx xxxx hili iiii
READ_HIGH_FUSES = lhlh hlll llll hlll xxxx xxxx xooo oooo
HIGH_FUSES_MESSAGE = 0xxxxxx - WDT always on
HIGH_FUSES_MESSAGE = x0xxxxx - serial programming enabled
HIGH_FUSES_MESSAGE = xx0xxxx - CKOPT max, datasheet p24
HIGH_FUSES_MESSAGE = xxx0xxx - eeprom not erased
HIGH_FUSES_MESSAGE = xxxxBZx - boot size, datasheet p215
HIGH_FUSES_MESSAGE = xxxxxx0 - reset at boot loader, p204
HIGH_FUSES_MESSAGE = Note: RSTDISBL is 1
WRITE_EXTD_FUSES =
READ_EXTD_FUSES =
EXTD_FUSES_MESSAGE =
READ_CALIBRATION = llhh hlll llxx xxxx llll llll oooo oooo
CALIB_MESSAGE = four calibration bytes (datasheet p28 p29 p218)